Conservazione dei prodotti

Prima della loro installazione, tutti i componenti del sistema

(tubi, raccordi, guarnizioni, staffaggi, etc.) devono essere la-

sciati nel loro imballaggio originale e conservati in un luogo

asciutto, al riparo dal contatto con acidi, basi, sali o altre so-

stanze corrosive e ne deve essere verificata l’integrità prima

dell’uso.

I tubi CSST non devono essere lasciati all’aperto prima della

loro installazione ed in ogni caso devono essere protetti dalla

luce solare diretta in caso di esposizione prolungata. In parti-

colare i tubi delle linee TWIN-SOLAR-SET e MONO-SUN-SET

devono essere immagazzinati in luogo pulito e asciutto a tem-

perature comprese tra +5°C e +30°C.

Per evitare che corpi estranei possano entrare all’interno dei

tubi, le sezioni terminali devono essere mantenute chiuse con

gli appositi tappi di fornitura oppure con nastro adesivo o altro

metodo equivalente.

Quando il tubo CSST viene srotolato dalla bobina, non deve

essere applicata una forza eccessiva per non deformarlo, non

deve essere tirato o sottoposto a torsione. È necessario inoltre

fare molta attenzione per non aggrovigliare il tubo o impigliar-

lo con altri elementi presenti sul luogo di installazione.

Preservation of the products

Before use, maintain all the components of tubing system

(tubes, fittings, gaskets, clamps, etc.) in their original packag-

es and store in a dry place, safe from the contact with acids,

bases, salts and any other corrosive substance and check the

integrity of the products before their use.

Do not leave CSST tubes outdoor before installation and al-

ways protect them against direct sun light when exposed for

a long time.

In particular TWIN-SOLAR-SET and MONO-SUN-SET have to

be stored in dry and clean warehouses with a temperature

between +5°C and +30°C.

To prevent foreing bodies from entering the tubes, maintain

the extremities closed with the supplied caps or with adhesive

tape or any other equivalent method.

When the CSST tube is unrolled from the coil, neither apply

excessive force to avoid deforming it , nor pull or twist it.

It is also necessary to be very careful not to tangle the tube or

get it caught with other elements present on the installation

site.

20 Sistemi Eurotis - Eurotis System