BC

Batteria calda ausiliaria, 2 ranghi

Auxiliary heating coil, 2 raws

MOR-

TMB(1)

Morsettiera tipo “Mammut” + Termostato minima temperatura acqua calda. Tset 32°C

Mammoth type terminal board + water low temperature thermostat. Tset 32°C

CRA (2)

Termostato a parete 230V - Contatti relè 5A/230V. Selettore ventilatore 3 velocità + Selettore Off-On-

Manuale + Gestione impianto 2 tubi con o senza valvole on-off 230V

230V wall thermostat. 3 speeds fan selector + Off/On selector + 2 pipes plant management with or without

230V on-off valves

CRR (2)

Termostato a parete 230V - Contatti relè 5A/230V. Selettore ventilatore 3 velocita + Selettore Off- On-Manuale

+ Cambio stagione da contatto remoto + Gestione impianto 2 tubi con o senza valvole on-off 230V

230V wall mounted thermostat. 3 speeds fan selector + Off/On selector + remote seasonal changeover +

2 pipes plant management with or without 230V on-off valves

CRB (2)

Termostato digitale a parete 230V/24V - Contatti relè 3A/230V. Selettore ventilatore 3 velocità e auto +

Gestione impianto 2 o 4 tubi con o senza valvole on-off, PWM, 3 punti, resistenze

230V/24V wall digital thermostat. 3 ways and auto selector + 2 or 4 pipes plant management with or

without on-off valves, PWM, 3 points, electrical heaters

CBP (2)

Termostato digitale a parete 230V/24V - Contatti relè 3A/230V. Ventilatore on-off o brushless, gestione

impianto 2 o 4 tubi con o senza valvole on-off o 0..10V alimentate 230V o 24V

Digital wall thermostat 230V/24V. On-off or brushless fan, 2 or 4 pipes plant management with or without

on-off valve or 0..10V with 230V or 24V alimentation.

TEL

Sistema per gestione con telecomando. Scheda madre+Sonda aria+Sonda acqua+Ricevitore

i.r.+Telecomando (gestione 2/4 tubi, con/senza valvole). Ventilatore 7A-230Vac. Valvole: 2A-230Vac.

Remote control management system .Motherboard + Air sensor + Water sensor - I.R. reciever + I.R.

Remote control (control 2-4 pipe units, with/without valves). Fan 7A-230Vac. Valves: 2A-230Vac.

SDI.4X3A

Scheda con 4 uscite da 3A (idonea per controllare fino a max n° 4 motori 3-Velocit

à da 3A; es. n°4 piccoli

fan-coils)

Card with 4 by 3A output (suitable to control up to max No. 4 3-Speed 3A motors ; ex. No. 4 small fan-coils)

Contatti-Contacts: 4x 3(0,3)A 230Vac

SDI.2X10A

Scheda con 2 uscite da 10A (idonea per controllare fino a max n° 2 motori a 3-Velocità da 10A ; es. n°1

grande unità con 2-motori)

Card with 2 by 10A output (suitable to control up to max No. 2 3-Speed motors of 10A ; ex. No. 1 large unit

with 2 motors)

Contatti-Contacts: 2x l0A-230Vac

RE

Resistenza elettrica integrata all’interno dell’unità + termostato di sicurezza “TS” (senza relay di potenza)

230V/50Hz/1Ph

Electrical heater integrated inside the units + “TS” safety thermostat (without power relay) 230V/50Hz/1Ph

MB

Motore brushless con variazione continua 0-100% della portata aria (segnale 0..10 Vdc)

-50% consumo annuo energia elettrica

-50% emissioni CO2

-50% livello di rumorosità

Brushless motor with continuos variation 0-100% of the air flow (signal 0..10 Vdc)

-50% yearly energy consumption

-50% CO2 emissions

-50% noise level

Accessorio indispensabile per il funzionamento di una unità con motore Brushless è il regolatore con

segnale di controllo modulante 0..10 Vdc, accessorio CBP.

An essential accessory for the operation of a unit with Brushless motor is the controller with modulating

control signal 0..10 Vdc, accessory CBP.

162

A

I

R

C

O

N

D

I

T

I

O

N

I

N

G

(1) Tutte le unità HCN sono fornite complete di morsettiera standard tipo “Mammut”, senza termostato. / All HCN units are supplied with standard Mammoth type terminal board, without thermostat.

(2) Ogni pannello comandi può controllare una sola unità (vedi accessorio “SDI”). / Each control panel can control only one unit (see accessory “SDI”).

Pompe di Calore & Gamma Industriale 2022

H

Y

D

R

O

N

I

C

T

E

R

M

I

N

A

L

S