POSA A SECCO SU SABBIA.

LAYING ON SAND.

TROCKENE VERLEGUNG AUF SAND / POSE SUR SABLE

STRATIGRAFIA SUGGERITA

SUGGESTED STRATIGRAPHY

Preparare uno strato di sabbia di almeno 5 cm di spessore sul

sottofondo esistente (massetto o superficie ghiaiosa). Livellare la

superficie con la staggia e verificarne la planarità.

Eine mindestens 5 cm dicke Sandschicht auf dem vorhandenen Untergrund (Estrich

oder kieshaltiger Boden) vorbereiten. Die Oberfläche mit einem Streichbrett ebnen und

anschließend die Ebenheit überprüfen.

Prepare a layer of sand at least 5 cm thick on the existing substrate

(screed or gravel). Level the surface with a straightedge and check

the flatness.

Préparer une couche de sable d’au moins 5 cm d’épaisseur sur le fond existant (chape ou

surface de gravier). Niveler la surface à l’aide d’une règle et en vérifier la planéité.

Posizionare le lastre a secco sulla sabbia e verificare che la

distanza tra l’una e l’altra sia regolare per tutta la superficie

di posa. Battere leggermente con la mazzetta di gomma per

stabilizzare la posa.

Die Platten trocken auf dem Sand positionieren und prüfen, dass der Abstand von einer

zur anderen Platte entlang der gesamten Verlegungsfläche gleich ist. Die Platten leicht

mit dem Gummihammer abklopfen, um die Verlegung zu stabilisieren.

Place the slabs dry on the sand and check that the gap between them

is the same over the entire laying surface. Tap down gently with a

rubber hammer to settle them into place.

Poser les dalles à sec sur le sable et s’assurer que la distance les séparant est régulière

sur toute la surface de pose. Battre légèrement à l’aide d’un maillet en caoutchouc pour

stabiliser la pose.

OPEN

SABBIA (2/5 CM)

SAND (2/5 CM)

GHIAIA Ø 0/20 MM (20/40 CM)

GRAVEL Ø 0/20 MM (20/40 CM)

GHIAIA Ø 40/80 MM (30/50 CM)

GRAVEL Ø 40/80 MM (30/50 CM)

114

INSTALLATION SYSTEMS 115

Aggiungere sabbia tra le fughe per livellare la pavimentazione.

Pulire la superficie delle lastre.

Sand zwischen den Fugen hinzufügen, um den Bodenbelag zu nivellieren.

Die Oberfläche der Platten reinigen.

Add sand in the joints to level the paving. Clean the surface of

the slabs.

Ajouter du sable dans les joints pour niveler le sol. Nettoyer la surface des dalles.