ASSEMBLAGGIO GRUPPO DI SCARICO / CONVEYOR ASSEMBLY

1

2

3

1

2

3

INSTALLAZIONE / INSTALLATION

Seguire le indicazioni (rif. Fig. A) / Follow the directions as shown in Fig A.

1. Installare una valvola di intercettazione X a monte del disconnet-

tore.

2. Installare una valvola di intercettazione Y a valle del disconnet-

tore.

3. A valvole chiuse installare un filtro con tappo di spurgo Z a mon-

te del disconnettore, assicurandosi che sia rispettato il senso del

flusso indicato sul prodotto.

IMPORTANTE. L’installazione del filtro è fondamentale per il

buon funzionamento dell’apparecchio. Assicurarsi che in fase di

installazione non siano presenti corpi estranei nelle tubature.

4. Montare il disconnettore rispettando il senso indicato.

5. Chiudere le valvole 1-2-3.

6. Rimuovere la protezione in plastica dello scarico nella parte

inferiore del disconnettore.

7. Fissare il tubo di drenaggio al disconnettore.

8. Aprire lentamente la valvola di intercettazione a monte X.

9. Aprire lentamente le valvole del disconnettore seguendo l’ordine

3-2-1 da valle a monte, spurgare e richiudere.

10. Aprire lentamente la valvola di intercettazione a valle y.

11. Il disconnettore è in funzione. Controllare che non esistano per-

dite dalla valvola di drenaggio. In caso di perdite, controllare che

non ci sia un calo nella pressione a monte.

1/2. Inserire il coperchio superiore sul corpo del

convogliatore di scario

3. Fissare il coperchio al disconnettore con le

spine in dotazione

1/2. Insert the upper cover into the drain conveyor

3. Fix the cover to the back flow preventer with

the plugs included

1. Install an interception valve x upstream with respect to the

backflow preventer.

2. Install an interception valve y downstream with respect to the

backflow preventer.

3. When the valves are closed install a strainer with a bleed plug

upstream with respect to the preventer, making sure that water flows

in the direction indicated on the body.

WARNING

The strainer is essential if the preventer is to work properly. Make

sure that, during the installation there are no residual parts in the

pipes that may serious damage to the device.

4. Install the backflow preventer between the strainer and the down-

stream valve, always following the direction indicated on the body

5. Close valves 1-2-3

6. Remove the plastic protection of the discharge device in the lower

part of backflow preventer.

7. Fix the bleed pipe

8. Slowly open the upstream valve x

9. Slowly open the preventer valves, in the order 3-2-1, from downstre-

am to up upstream; let them bleed, and close

10. Slowly open the downstream valve y

11. The backflow preventer is now working. Make sure that the relief

valve does not leak. In case of leakage, check if there are pressure

decreases in the upstream section.

282

www.brandonivalves.it

V

A

L

V

E

S